Can one panel be replaced instead of the whole door?

Often yes, if the rest of the door is sound and the section is still available from the manufacturer. The technician checks the make, model and age of your door to see whether a match exists. If it does not, you will be told before anything is ordered or started.

The door still opens. Can I just leave it?

A creased panel weakens the whole door even while it still runs. In Miramar that matters more than most places, because the door has to hold against hurricane-season wind pressure and because broken paint on bare steel rusts fast in this humidity and salt air.

Will I need a permit in Miramar?

A permit is typically required in Florida to replace a garage door, because the door is part of the building envelope. Permits are issued and inspected by the local city or county building department, and submittal requirements vary. Confirm with the Miramar or Broward County building department for your address.

We do not quote prices, because the work depends on the door and what the impact did to it. The estimate is free. The technician looks at the door in person and gives you the price before any work starts, and you approve it first.

Who actually shows up?

One Call Garage Door is a referral and scheduling service. We arrange garage door service with independent local technicians across all fifty states. We are not the contractor and we do not perform the work ourselves.

Dented panel in Miramar, FL

You backed into the door, or something hit it, and now a section is bent. The crease may be small. The door may still go up and down. That does not mean it is fine. A creased panel weakens the whole door even while it still runs, because that section is what holds the door flat against wind and weight.

Call now · (866) 394-4210

Phones answered around the clock · free estimate

In Miramar, a bent panel is rarely just cosmetic. Garage doors here sit in constant heat and very high humidity, and salt-laden air drifting in from the Atlantic a few miles east rusts exposed metal even though the city is inland. Once a panel is creased, the paint and coating break and bare steel is open to that air. Add the wind pressure that comes with hurricane season, June 1 through November 30, and a weakened section on a two-car door in Sunset Lakes or Riviera Isles is worth looking at sooner rather than later.

While you wait — please don't

Do not keep cycling the door. Every open and close works the crease further and can pull hinges, rollers and track out of line.
Stop using the door if it has come off track. A door off its track or hanging crooked can fall, and that is not a repair to attempt yourself.
Leave the springs and cables alone. The springs and cables are under extreme tension and can cause serious injury, so do not loosen, adjust or unhook anything near them.
Do not hammer the dent out. Pounding a creased section stretches the steel further and can turn a one-panel repair into a full door replacement.
Do not park under a damaged door. If the section is bowed or the door is binding, move the car out and keep people and pets clear until it has been looked at.

What the technician does

The damage gets looked at firstThe technician checks whether the crease is limited to one section or whether the bend has carried into the sections above and below.
Panel availability is checkedMatching a single section depends on the door's make, model and age. Older discontinued doors often cannot be matched, and the technician will tell you straight if that is the case.
Single section replacementWhere the rest of the door is sound, one damaged section can often be swapped out rather than replacing the whole door.
Struts where a section has bowedIf a section has bowed rather than creased, a strut can be added across it to stiffen the panel and keep it flat.
Rollers, hinges and track checkedAn impact rarely stops at the panel, so hinges, rollers and track are checked for knock-on damage and bending.
Price before any workThe technician looks at the door and gives you the price first. You approve it before anything starts.

Why this happens in Miramar, FL

Miramar's housing splits in two, and so does this repair. East of the Turnpike, Historic Miramar is mostly 1950s and 1960s single-story concrete-block ranch homes with carports or single-car garages. Those doors are often old enough that a matching section no longer exists. West Miramar, built out from the 1990s through the 2000s, is two-story CBS homes with attached two-car garages, plus a lot of townhomes and condos, and those doors are newer and more likely to be matchable section by section.

There is a code side to this too. Miramar sits in Broward County's high-wind zone, inside the High-Velocity Hurricane Zone, where garage doors generally must meet Florida Building Code impact and pressure ratings adopted after Hurricane Andrew, and products typically require a Miami-Dade Notice of Acceptance or equivalent Florida Product Approval. That is why a full replacement on an older eastern Miramar home is rarely a like-for-like swap of pre-1990s equipment. A permit is typically required to replace a garage door in Florida, and permits are issued and inspected locally, so verify the rating and the paperwork required for your address with the local building department. Demand climbs in late spring as residents get ready for storm season and again after each named storm, so a bent panel is better handled before that rush.

Questions people ask

Can one panel be replaced instead of the whole door?: Often yes, if the rest of the door is sound and the section is still available from the manufacturer. The technician checks the make, model and age of your door to see whether a match exists. If it does not, you will be told before anything is ordered or started.
The door still opens. Can I just leave it?: A creased panel weakens the whole door even while it still runs. In Miramar that matters more than most places, because the door has to hold against hurricane-season wind pressure and because broken paint on bare steel rusts fast in this humidity and salt air.
Will I need a permit in Miramar?: A permit is typically required in Florida to replace a garage door, because the door is part of the building envelope. Permits are issued and inspected by the local city or county building department, and submittal requirements vary. Confirm with the Miramar or Broward County building department for your address.
What does it cost?: We do not quote prices, because the work depends on the door and what the impact did to it. The estimate is free. The technician looks at the door in person and gives you the price before any work starts, and you approve it first.
Who actually shows up?: One Call Garage Door is a referral and scheduling service. We arrange garage door service with independent local technicians across all fifty states. We are not the contractor and we do not perform the work ourselves.

One call

One call at (866) 394-4210 and we arrange for an independent local technician to come look at the damaged panel in Miramar. The estimate is free, and the price is agreed with you before any work starts.

Call now · (866) 394-4210

Same problem in nearby cities

Every city we cover in Florida

Something else in this area

One Call Garage Door arranges the visit; the technician does the work and gives you the price.